- 您现在的位置：买卖IC网 > PDF目录14458 > LT3430IFE-1#PBF (Linear Technology)IC REG BUCK ADJ 3A 16TSSOP PDF资料下载
参数资料
| 型号： | LT3430IFE-1#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 10/28页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3A 16TSSOP |
| 标准包装： | 95 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 1.2 V ~ 54 V |
| 输入电压： | 5.5 V ~ 60 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 100kHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 16-TSSOP-EP |
| 产品目录页面： | 1331 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT3430/LT3430-1
APPLICATIONS INFORMATION
inductor value to achieve a desirable output ripple volt-
age level. If output ripple voltage is of less importance,
the subsequent suggestions in Peak Inductor and Fault
Current and EMI will additionally help in the selection of
the inductor value.
Peak-to-peak output ripple voltage is the sum of a triwave
(created by peak-to-peak ripple current (I LP-P ) times ESR)
and a square wave (created by parasitic inductance (ESL)
and ripple current slew rate). Capacitive reactance is as-
sumed to be small compared to ESR or ESL.
Ceramic Output Capacitor
An alternative way to further reduce output ripple voltage
is to reduce the ESR of the output capacitor by using a
ceramic capacitor. Although this reduction of ESR removes
a useful zero in the overall loop response, this zero can
be replaced by inserting a resistor (R C ) in series with the
V C pin and the compensation capacitor C C . (See Ceramic
Capacitors in Applications Information.)
Peak Inductor Current and Fault Current
V RIPPLE = ( I LP - P )( ESR ) + ( ESL )
dI
dt
To ensure that the inductor will not saturate, the peak
inductor current should be calculated knowing the
maximum load current. An appropriate inductor should
where:
ESR = equivalent series resistance of the output capaci-
tor
ESL = equivalent series inductance of the output capaci-
tor
dI/dt = slew rate of inductor ripple current = V IN /L
Peak-to-peak ripple current (I LP-P ) through the inductor
then be chosen. In addition, a decision should be made
whether or not the inductor must withstand continuous
fault conditions.
If maximum load current is 1A, for instance, a 1A induc-
tor may not survive a continuous 4A overload condition.
Dead shorts will actually be more gentle on the inductor
because the LT3430/LT3430-1 have frequency and current
limit foldback.
( V OUT )( V IN – V OUT )
( V IN )( f )( L )
and into the output capacitor is typically chosen to be
between 20% and 40% of the maximum load current. It
is approximated by:
I LP - P =
Example: with V IN = 40V, V OUT = 5V, L = 22μH, ESR =
0.080 Ω and ESL = 10nH, output ripple voltage can be
approximated as follows:
Table 2
VENDOR/
PART NO.
Sumida
CDRH104R-150
CDRH104R-220
CDRH104R-330
CDRH124-220
CDRH124-330
VALUE
(μH)
15
22
33
22
33
I DC
(Amps)
3.6
2.9
2.3
2.9
2.7
DCR
(Ohms)
0.050
0.073
0.093
0.066
0.097
HEIGHT
(mm)
4
4
4
4.5
4.5
I P-P =
( 5 ) ( 40 ? 5 )
( 40 ) ( 22 ? 10 ? 6 )( 200 ? 10 3 )
= 0 . 99 A
CDRH127-330
CDRH127-470
CEI122-220
33
47
22
3.0
2.5
2.3
0.065
0.100
0.085
8
8
8
= = 10 6 ? 1 . 8
V RIPPLE = ( 0 . 99 A )( 0 . 08 ) + ( 10 ? 10 )( 10 6 ) ( 1 . 8 )
dI 40
dt 22 ? 10 ? 6
? 9
= 0 . 079 + 0 . 018 = 97 mV P-P
To reduce output ripple voltage further requires an increase
in the inductor value with the trade-off being a physically
Coiltronics
UP3B-330
UP3B-470
UP4B-680
Coilcraft
DO3316P-153
DO5022p-683
33
47
68
15
68
3
2.4
4.3
3
3.5
0.069
0.108
0.120
0.046
0.130
6.8
6.8
7.9
5.2
7.1
larger inductor with the possibility of increased component
height and cost.
10
34301fa
相关PDF资料 |
PDF描述 |
|---|---|
| LT1374HVCR#PBF | IC REG BUCK ADJ 4.5A D2PAK |
| LT1941EFE#PBF | IC REG MULTI CONFIG TRPL 28TSSOP |
| LT1506CR-3.3#PBF | IC REG BUCK 3.3V 4.5A D2PAK |
| RCA35DTAN | CONN EDGECARD 70POS R/A .125 SLD |
| EBM10DTAT-S273 | CONN EDGECARD 20POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3430IFEPBF | 制造商:Linear Technology 功能描述:Sw. Regulator 3A 200kHz 60V TSSOP16EP |
| LT3431 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, 3A,500kHz Step-Down Switching Regulator |
| LT3431EFE | 功能描述:IC REG BUCK ADJ 3A 16TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3431EFE#PBF | 功能描述:IC REG BUCK ADJ 3A 16TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| LT3431EFE#TR | 功能描述:IC REG BUCK ADJ 3A 16TSSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。