- 您现在的位置：买卖IC网 > PDF目录14459 > LTC3546EUFD#PBF (Linear Technology)IC REG BUCK SYNC ADJ 1A/2A 28QFN PDF资料下载
参数资料
| 型号： | LTC3546EUFD#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 16/30页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 1A/2A 28QFN |
| 标准包装： | 73 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.6 V ~ 5 V |
| 输入电压： | 2.25 V ~ 5.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 2.25MHz，750kHz ~ 4MHz |
| 电流 - 输出： | 1A，2A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 28-QFN（4x5） |
| 产品目录页面： | 1335 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LTC3546
APPLICATIONS INFORMATION
the maximum RMS current. The RMS current calculation
is different if the part is used in-phase or out-of-phase.
For in-phase, there are two different equations:
V OUT1 > V OUT2 :
when V OUT1 – V IN /2 = V OUT2 and when V OUT2 – V IN /2 =
V OUT1 . As a good rule of thumb, the amount of worst-case
ripple is about 75% of the worst-case ripple in the in-phase
mode. Note, that when V OUT1 = V OUT2 = V IN /2 and I 1 = I 2 ,
the ripple is at its minimum.
I RMS =
V OUT2 > V OUT1 :
I RMS =
2 ? I1 ? I2 ? D2 ( 1–D1 ) + I2 2 ( D2 –D2 2 ) + I1 2 ( D1–D1 2
2 ? I1 ? I2 ? D1 ( 1–D2 ) + I2 2 ( D2 –D2 2 ) + I1 2 ( D1–D1 2
)
)
Note that capacitor manufacturer’s ripple current ratings
are often based on only 2000 hours lifetime. This makes
it advisable to further derate the capacitor, or choose a
capacitor rated at a higher temperature than required.
Several capacitors may also be paralleled to meet the
size or height requirements of the design. An additional
0.1μF to 1μF ceramic capacitor is also recommended on
V IN for high frequency decoupling, when not using an all
ceramic capacitor solution.
D1 = OUT1 and D2 = OUT2
V OUT ( V IN – V OUT )
I RMS = ( I1 + I2 )
I1 = I LIM1 –
Δ V OUT ≈ Δ I L ? ESR +
Δ I L2
I2 = I LIM2 –
Where:
V V
V IN V IN
When D1 = D2, then the equation simplifies to:
I RMS = ( I1 + I2 ) D ( 1–D )
or
V IN
where the maximum average output currents I1 and
I2 equals the peak current minus half the peak-to-peak
ripple current:
Δ I L1
2
2
These formula have a maximum at V IN = 2V OUT , where
I RMS = (I1 + I2)/2. This simple worst-case is commonly
used to determine the worst-case I RMS .
For out-of-phase (PHASE pin is at ground), the ripple
current can be lower than the in-phase.
In the out-of-phase case, the maximum I RMS does not oc-
cur when V OUT1 = V OUT2 . The maximum typically occurs
Output Capacitor (C OUT1 and C OUT2 ) Selection
The selection of C OUT1 and C OUT2 is driven by the required
ESR to minimize voltage ripple and load step transients.
Typically, once the ESR requirement is satisfied, the
capacitance is adequate for filtering. The output ripple
( Δ V OUT ) is determined by:
? 1 ?
?
? 8 ? f O ? C OUT ?
where f O = operating frequency, C OUT = output capacitance
and Δ I L = ripple current in the inductor. The output ripple
is highest at maximum input voltage since Δ I L increases
with input voltage.
Once the ESR requirements for C OUT have been met, the
RMS current rating generally far exceeds the I RIPPLE(P-P)
requirement, except for an all ceramic solution.
In surface mount applications, multiple capacitors may
have to be paralleled to meet the capacitance, ESR or RMS
current handling requirement of the application. Aluminum
electrolytic, special polymer, ceramic and dry tantalum
capacitors are all available in surface mount packages.
The OS-CON semiconductor dielectric capacitor avail-
able from Sanyo has the lowest ESR(size) product of any
aluminum electrolytic at a somewhat higher price. Special
polymer capacitors, such as Sanyo POSCAP, offer very
low ESR, but have a lower capacitance density than other
types. Tantalum capacitors have the highest capacitance
16
For more information www.linear.com/3546
3546fc
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1514IS8-5#PBF | IC REG MULTI CONFIG 5V 8SOIC |
| LT3510IFE#PBF | IC REG BUCK ADJ 2A DL 20TSSOP |
| VE-J2H-EX-B1 | CONVERTER MOD DC/DC 52V 75W |
| VE-J23-EX-B1 | CONVERTER MOD DC/DC 24V 75W |
| VE-J22-EX-B1 | CONVERTER MOD DC/DC 15V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3546EUFDTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous, 3A/1A or 2A/2A Confi gurable Step-Down DC/DC Regulator |
| LTC3546IFE#PBF | 功能描述:IC REG BUCK SYNC ADJ DL 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3546IFE#TRPBF | 功能描述:IC REG BUCK SYNC ADJ DL 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LTC3546IFEPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous, 3A/1A or 2A/2A Confi gurable Step-Down DC/DC Regulator |
| LTC3546IFETRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual Synchronous, 3A/1A or 2A/2A Confi gurable Step-Down DC/DC Regulator |
发布紧急采购，3分钟左右您将得到回复。