参数资料
| 型号： | XRT7300IVTR |
| 厂商： | Exar Corporation |
| 文件页数： | 40/55页 |
| 文件大小： | 0K |
| 描述： | IC LIU E3/DS3/STS-1 SGL 44TQFP |
| 标准包装： | 1,000 |
| 类型： | 线路接口装置（LIU） |
| 驱动器/接收器数： | 1/1 |
| 规程： | DS3，E3，STS-1 |
| 电源电压： | 4.75 V ~ 5.25 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 44-LQFP |
| 供应商设备封装： | 44-TQFP（10x10） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页当前第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页
XRT7300
E3/DS3/STS-1 LINE INTERFACE UNIT
REV. 1.1.2
41
2. The Transmit Drive Monitor feature can also be
used to monitor the Transmit Output Line Signal of
another LIU IC as illustrated in Figure 32.
Presented in Figure 32, if LIU # 1 (U1) fails, then LIU
# 2 (U2) drives its DMO output pin “High”. Likewise, if
LIU # 2 (U2) fails, then LIU # 1 (U1) drives its DMO
output pin “High”.
The scheme presented in Figure 32 is a better design
approach. It overcomes situations in which a LIU
monitoring its own signal (Figure 31) may experience
a failure mode such that it cannot drive a bipolar sig-
nal onto the line. That same failure mode may pre-
vent the LIU from driving the DMO output pin “High”.
4.6
THE TAOS (TRANSMIT ALL ONES) FEATURE
The XRT7300 can transmit an all “1’s” pattern onto
the line by toggling a single input pin or by setting a
single bit-field in one of the Command Registers to
“1”.
NOTE: When this feature is activated, the Transmit Section
of the XRT7300 overwrites the Terminal Equipment data
with this all “1’s” pattern.
This feature can be activated by either of the follow-
ing methods.
When the XRT7300 is operating in the Hardware
Mode:
Configure the device to transmit an all “1’s” pattern by
toggling the TAOS input pin (pin 2) “High”. Terminate
the all “1’s” pattern by toggling the TAOS input pin
“Low”.
When the XRT7300 is operating in the HOST
Mode:
If the XRT7300 is operating in the HOST Mode, the
TAOS input pin is disabled. Consequently, the
XRT7300 can be configured to transmit an all “1’s”
pattern by writing to Command Register CR1 and set-
ting the TAOS bit-field (bit D3) to “1”.
The all “1’s” pattern can be terminated by writing to
Command Register CR1 and setting the TAOS bit-
field (D3) to “0".
FIGURE 32. TWO LIU’S, EACH MONITORING THE TRANSMIT OUTPUT SIGNAL OF THE OTHER LIU IC
R1
36
BNC
T1
R2
36
R7
36
BNC
R8
36
TTIP
TRING
R3
270
R4
270
R5
270
R6
270
TRING
TTIP
MRING
MTIP
MRING
MTIP
DMO_Channel_2
DMO_Channel_1
DMO
T2
PE-68629
TXOFF
U1
U2
COMMAND REGISTER CR1 (ADDRESS = 0X01)
D4
D3
D2
D1
D0
TXOFF
TAOS
TXCLKINV
TXLEV
TXBIN
0
1
X
相关PDF资料 |
PDF描述 |
|---|---|
| MS3101E28-18SW | CONN RCPT 12POS FREE HNG W/SCKT |
| XRT73L02MIVTR-F | IC LIU E3/DS3/STS-1 2CH 100TQFP |
| MS27508E14B5SD | CONN RCPT 5POS BOX MNT W/SCKT |
| MS3100R22-15S | CONN RCPT 6POS WALL MNT W/SCKT |
| MS27467E15F97P | CONN PLUG 12POS STRAIGHT W/PINS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT7300IVTR-F | 功能描述:网络控制器与处理器 IC RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流（最大值）:595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray |
| XRT7302IV | 制造商:未知厂家 制造商全称:未知厂家 功能描述:PCM Transceiver |
| XRT73L00 | 制造商:EXAR 制造商全称:EXAR 功能描述:E3/DS3/STS-1 LINE INTERFACE UNIT |
| XRT73L00A | 制造商:EXAR 制造商全称:EXAR 功能描述:E3/DS3/STS-1 LINE INTERFACE UNIT |
| XRT73L00AES | 功能描述:界面开发工具 Eval System for XRT73L00A Series RoHS:否 制造商:Bourns 产品:Evaluation Boards 类型:RS-485 工具用于评估:ADM3485E 接口类型:RS-485 工作电源电压:3.3 V |
发布紧急采购，3分钟左右您将得到回复。