参数资料
| 型号： | XRT83VSH314IB |
| 厂商： | Exar Corporation |
| 文件页数： | 38/80页 |
| 文件大小： | 0K |
| 描述： | IC LIU SH T1/E1/J1 14CH 304TBGA |
| 标准包装： | 27 |
| 类型： | 线路接口装置（LIU） |
| 驱动器/接收器数： | 14/14 |
| 规程： | T1，E1，J1 |
| 电源电压： | 3.135 V ~ 3.465 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 304-BBGA |
| 供应商设备封装： | 304-PBGA（31x31） |
| 包装： | 托盘 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页当前第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页
XRT83VSH314
40
REV. 1.0.1
14-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT
NOTE: The Transmitter Line Side uses a 2:1 transformer.
4. If the measured signal is absent, there is either an open or short on the board.
5. A 1MHz signal applied to the Line Side TTIP pin should appear unattenuated on the Line Side TRING pin if
there is no open. This could also be indicitive of a short.
6. A 1MHz signal applied to the ATP_TIP pin should appear unattenuated on the ATP_RING pin if the line side
TTIP/TRING are appropriately terminated and there is no open. This could also be indicative of a short.
5.7.2
Receiver RTIP and RRING
Each channel of the device can be tested from the line side by doing the following, using the TMS and TCK as
describe above:
1. Apply a differential 2Vpp, 1MHz signal to the Rx Line Side channel TIP and RING pins.
2. Measure the signal at the device ATP_TIP and ATP_RING pins.
3. If the voltaged measured on the ATP_TTIP ATP_TRING pins is 2Vpp±20%, your assembly is correct.
NOTE: The Receiverr Line Side uses a 1:1 transformer.
4. If the measured signal is absent, there is either an open or short on the board.
5. A 1 MHZ or 1kHZ signal applied to the Line Side RTIP pin should appear attenuated on the Line Side
RRING pin if there is no open. This could also be indicative of a short.
6. A 1kHZ signal applied to the ATP_TIP pin should appear slightly attenuated on the ATP_RING pin if the line
side RTIP/RRING are appropriately terminated and there is no open. This could also be indicitive of a short.
The Receiver Device Side transformer is center tapped and capacitively connected to ground which would
cause a 1MHz signal to be severely attenuated.
相关PDF资料 |
PDF描述 |
|---|---|
| MS27508E12B98PA | CONN RCPT 10POS BOX MNT W/PINS |
| SP503CM-L | IC TXRX MULTIPROTOCOL 80LQFP |
| ISL26310FBZ | IC ADC 12BIT SPI/SRL 125K 8SOIC |
| IDT72V243L6BCG | IC FIFO 2048X18 6NS 100BGA |
| MS27473E16A35SA | CONN PLUG 55POS STRAIGHT W/SCKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| XRT83VSH314IB-F | 功能描述:外围驱动器与原件 - PCI 14 Channel Short-Haul RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
| XRT83VSH314IB-SAM | 制造商:Exar Corporation 功能描述:FOR FUJITSU ONLY |
| XRT83VSH316 | 制造商:EXAR 制造商全称:EXAR 功能描述:16-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH316_07 | 制造商:EXAR 制造商全称:EXAR 功能描述:16-CHANNEL T1/E1/J1 SHORT-HAUL LINE INTERFACE UNIT |
| XRT83VSH316ES | 功能描述:外围驱动器与原件 - PCI 16 CH T1/E1LIUSH LOW COST VERSION RoHS:否 制造商:PLX Technology 工作电源电压: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:FCBGA-1156 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。