参数资料
| 型号： | LT6204IS#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 13/28页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP R-R INOUT QUAD LP14SOIC |
| 标准包装： | 55 |
| 放大器类型： | 通用 |
| 电路数： | 4 |
| 输出类型： | 满摆幅 |
| 转换速率： | 25 V/µs |
| 增益带宽积： | 100MHz |
| 电流 - 输入偏压： | 3.8µA |
| 电压 - 输入偏移： | 2600µV |
| 电流 - 电源： | 2.8mA |
| 电流 - 输出 / 通道： | 40mA |
| 电压 - 电源，单路/双路(±)： | 2.5 V ~ 12.6 V，±1.25 V ~ 6.3 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 14-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 14-SO |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LT6202/LT6203/LT6204
20
620234fd
TYPICAL APPLICATIONS
Low Noise, Low Power 1MΩ AC
Photodiode Transimpedance Amplifier
Figure 3 shows the LT6202 applied as a transimpedance
amplifier(TIA).TheLT6202forcestheBF862ultralow-noise
JFET source to 0V, with R3 ensuring that the JFET has an
IDRAINof1mA.TheJFETactsasasourcefollower,buffering
the input of the LT6202 and making it suitable for the high
impedance feedback elements R1 and R2. The BF862 has
a minimum IDSS of 10mA and a pinchoff voltage between
–0.3V and –1.2V. The JFET gate and the LT6202 output
therefore sit at a point slightly higher than one pinchoff
voltage below ground (typically about –0.6V). When the
photodiode is illuminated, the current must come from the
LT6202’s output through R1 and R2, as in a normal TIA.
Amplifier input noise density and gain-bandwidth product
were measured at 2.4nV/Hz and 100MHz, respectively.
Note that because the JFET has a high gm, approximately
1/80Ω, its attenuation looking into R3 is only about 2%.
Gain-bandwidth product was measured at 100MHz and
the closed-loop bandwidth using a 3pF photodiode was
approximately 1.4MHz.
Precision Low Noise, Low Power, 1MΩ
Photodiode Transimpedance Amplifier
Figure 4 shows the LT6202 applied as a transimpedance
amplifier (TIA), very similar to that shown in Figure 3.
In this case, however, the JFET is not allowed to dictate
the DC-bias conditions. Rather than being grounded, the
LT6202’s noninverting input is driven by the LTC2050 to
the exact state necessary for zero JFET gate voltage. The
noise performance is nearly identical to that of the circuit
in Figure 3, with the additional benefit of excellent DC per-
formance. Input offset was measured at under 200V and
outputnoisewaswithin2mVP-Povera20MHzbandwidth.
–
+
VBIAS–
PHILIPS
BF862
R1
499k
R2
499k
C1
1pF
VS–
VS+
VOUT
VS = ±5V
LT6202
R3
4.99k
LT6202/03/04 F03
Figure 3. Low Noise, Low Power 1MΩ
AC Photodiode Transimpedance Amplifier
–
+
VBIAS–
PHILIPS
BF862
R1
499k
R2
499k
C1
1pF
VS–
VS+
VOUT
VS = ±5V
R3
4.99k
C2
0.1F
LTC2050HV
R4
10M
R5
10k
C3
1F
LT6202/03/04 F04
–
+
LT6202
Figure 4. Precision Low Noise, Low Power Transimpedance Amplifier
相关PDF资料 |
PDF描述 |
|---|---|
| 1-826375-6 | CONN MTIS SGL VERT BLACK 16POS |
| RMCF1206FT20K0 | RES 20K OHM 1/4W 1% 1206 SMD |
| 60598-7 | CONN UNINSUL RECEPT 20-24AWG |
| AD8426BCPZ-WP | IC AMP INSTR RR 1.5MHZ 16LFCSP |
| 61782-2 | CONN EDGE DISCONNECT 16-22AWG |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT6205 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Single/Dual/Quad Single Supply 3V, 100MHz Video Op Amps |
| LT6205_1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Single/Dual/Quad Single Supply 3V, 100MHz Video Op Amps |
| LT6205CS5 | 制造商:Linear Technology 功能描述:OP Amp Single Volt Fdbk R-R O/P ±6.3V/12.6V 5-Pin TSOT-23 |
| LT6205CS5#PBF | 制造商:Linear Technology 功能描述:SC-Amps/High Speed, Cut Tape 3V 100MHz, Video Op Amp |
| LT6205CS5#TR | 功能描述:IC OPAMP VID SGL 100MHZ TSOT23-5 RoHS:否 类别:集成电路 (IC) >> 线性 - 放大器 - 视频放大器和频缓冲器 系列:- 标准包装:1,000 系列:- 应用:驱动器 输出类型:差分 电路数:3 -3db带宽:350MHz 转换速率:1000 V/µs 电流 - 电源:14.5mA 电流 - 输出 / 通道:60mA 电压 - 电源，单路/双路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 供应商设备封装:20-QFN 裸露焊盘（4x4） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。