- 您现在的位置：买卖IC网 > Datasheet目录370 > ZXLD1362ET5TA (Diodes Inc)IC LED DRIVR WHITE BCKLGT TSOT-5 Datasheet资料下载
参数资料
| 型号： | ZXLD1362ET5TA |
| 厂商： | Diodes Inc |
| 文件页数： | 20/24页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVR WHITE BCKLGT TSOT-5 |
| 特色产品： | LED Driver Solutions ZXLD1362 - Miniature 1A LED Driver |
| 标准包装： | 1 |
| 拓扑： | PWM，降压（降压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 车载，背光 |
| 类型 - 次要： | 高亮度 LED（HBLED） |
| 频率： | 500kHz |
| 电源电压： | 6 V ~ 60 V |
| 输出电压： | 60V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | SOT-23-5 细型，TSOT-23-5 |
| 供应商设备封装： | TSOT-23-5 |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 125°C |
| 产品目录页面： | 1478 (CN2011-ZH PDF) |
| 其它名称： | ZXLD1362ET5DKR |
A Product Line of
Diodes Incorporated
ZXLD1362
Application Information (cont.)
Diode Selection
For maximum efficiency and performance, the rectifier (D1)
should be a fast low capacitance Schottky diode* with low
reverse leakage at the maximum operating voltage and
temperature.
They also provide better efficiency than silicon diodes, due to a
combination of lower forward voltage and reduced recovery
time.
It is important to select parts with a peak current rating above
the peak coil current and a continuous current rating higher
than the maximum output load current. It is very important to
consider the reverse leakage of the diode when operating
above +85°C. Excess leakage will increase the power
dissipation in the device and if close to the load may create a
thermal runaway condition.
The higher forward voltage and overshoot due to reverse
recovery time in silicon diodes will increase the peak voltage
on the LX output. If a silicon diode is used, care should be
taken to ensure that the total voltage appearing on the LX pin
including supply ripple, does not exceed the specified
maximum value.
*A suitable Schottky diode would be 30BQ100PBF (IR).
Reducing Output Ripple
Peak to peak ripple current in the LED(s) can be reduced, if
required, by shunting a capacitor Cled across the LED(s) as
shown below:
V ? IN
Rs
D1
LED
L1
Cled
V IN
I SE NSE
ZXLD1362
LX
A value of 1 μ F will reduce the supply ripple current by a factor
three (approx.). Proportionally lower ripple can be achieved
with higher capacitor values. Note that the capacitor will not
affect operating frequency or efficiency, but it will increase
start-up delay, by reducing the rate of rise of LED voltage.
By adding this capacitor the current waveform through the
LED(s) changes from a triangular ramp to a more sinusoidal
version without altering the mean current value.
Operation at Low Supply Voltage
Below the under-voltage lockout threshold (VSD) the drive to
the output transistor is turned off to prevent device operation
with excessive on-resistance of the output transistor. The
output transistor is not full enhanced until the supply voltage
exceeds approximately 17V. At supply voltages between V SD
and 17V care must be taken to avoid excessive power
dissipation due to the on-resistance.
If the supply voltage is always less than 30V continuous an
alternative device is available, the ZXLD1360 or the AL8805.
Note that when driving loads of two or more LEDs, the forward
drop will normally be sufficient to prevent the device from
switching below approximately 6V. This will minimize the risk of
damage to the device.
ZXLD1362
Document number: DS33472 Rev. 5 - 2
20 of 24
www.diodes.com
May 2012
? Diodes Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| ZXLD1366DACTC | IC LED DRIVER WHITE BCKLGT 6-DFN |
| ZXLD1370EST16TC | IC LED DRVR HIGH BRIGHT TSSOP-16 |
| ZXLD1371QESTTC | IC LED DRIVER |
| ZXLD1374EST20TC | IC LED DVR BUCK BOOST 20TSSOP |
| ZXLD1937ET5TA | IC LED DRIVR WHITE BCKLGT TSOT-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ZXLD1362ET5TA-CUT TAPE | 制造商:DIODES 功能描述:ZXLD1362 Series 1 A 1 MHz SMT LED Driver with Internal Switch - TSOT-23-5 |
| ZXLD1366 | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:High accuracy 1A, 60V LED driver with internal switch |
| ZXLD1366_10 | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:HIGH ACCURACY 1A, 60V LED DRIVER WITH INTERNAL SWITCH |
| ZXLD1366DACTC | 功能描述:LED照明驱动器 1A, 60V LED Drver, Int Swtch RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| ZXLD1366DACTC-CUT TAPE | 制造商:DIODES 功能描述:ZXLD1366 Series 1A 500 kHz High Accuracy LED Driver with Internal Switch - DFN-6 |
发布紧急采购，3分钟左右您将得到回复。