- 您现在的位置：买卖IC网 > PDF目录10775 > X79001V20IT1 (Intersil)IC DAC NV SELECT OUT/MEM 20TSSOP PDF资料下载
参数资料
| 型号： | X79001V20IT1 |
| 厂商： | Intersil |
| 文件页数： | 3/18页 |
| 文件大小： | 0K |
| 描述： | IC DAC NV SELECT OUT/MEM 20TSSOP |
| 标准包装： | 2,500 |
| 设置时间： | 6µs |
| 位数： | 12 |
| 数据接口： | 串行 |
| 转换器数目： | 1 |
| 电压电源： | 单电源 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 20-TSSOP |
| 包装： | 带卷 (TR) |
| 输出数目和类型： | 1 电压，单极 |
| 采样率（每秒）： | 417k |
11
FN8147.0
March 17, 2005
FUNCTIONAL DESCRIPTION
DAC Register Clear Function
When the input pin CLR is set to logic high, the DAC
volatile register and serial input registers are reset to 000
hex. CLR is an asynchronous input. CLR has an on-chip
pulldown. CLR is ignored while RDY is high.
Buffer Output Enable Function
When the input pin OE is set to logic low, the DAC
buffered output, Vbuf, is set to high impedance.
When the input pin OE is at a logic high, the DAC
buffered output is enabled.
UP/DOWN Interface
The UP/DOWN Interface can be used to change the
value of the DAC register without using the serial
Interface.
The CS pin must be HIGH, when the UP/DOWN
Interface is used, to set the serial interface in standby
mode.
Control bits Count8 and Count10 determine the binary
word that is incremented or decremented, according to
the following table:
These control bits are set by performing a Write
Operation with the serial interface prior to operation of
the UP/DOWN interface.
For example, when Count8 is one, the DAC register
is affected by increment or decrement operations as
follows:
A HIGH to LOW transition on the UP pin, while the
DOWN pin is LOW, increments the selected binary word
by one.
A HIGH to LOW transition on the DOWN pin, while
the UP pin is LOW, decrements the selected binary
word by one.
Other combinations are not valid. See the following table
for a summary of these operations.
X = Don’t Care
RDY Pin
The RDY pin is an open drain output which will follow the
VCC voltage on power-up (due to the pullups) resistor
and will transition to a low state at time tRDY after VCC
reaches a minimum voltage (VRDY). As long as VCC is
higher the VRDY, the output will remain low. If VCC falls
below VRDY, the RDY output will return to a high state.
Count8
Count10
Part of DAC register
incremented or
decremented.
0
The complete 12 bit word is used
0
1
10 MSBs are used
1
0
8 MSBs are used
11
Reserved
8 MSBs
4 LSBs
1000 1011
1000 1010
1110
Increment
1000 1001
1110
Initial Value
1000 1000
1000 0111
1110
Decrement
CS
Up
Down
Mode
L
X
SPI Control
H
L
Increment
H
L
Decrement
H
Not Allowed
H
Not Allowed
X79000, X79001, X79002
相关PDF资料 |
PDF描述 |
|---|---|
| VE-J6B-MW-F3 | CONVERTER MOD DC/DC 95V 100W |
| X79001V20I | IC DAC NV SELECT OUT/MEM 20TSSOP |
| B37941K5472K060 | CAP CER 4700PF 50V 10% X7R 0805 |
| X79000V20IT1 | IC DAC NV SELECT OUT/MEM 20TSSOP |
| VE-J6B-MW-F1 | CONVERTER MOD DC/DC 95V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| X79002 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:NV DAC with Selectable Output Range and Memory |
| X79002V20I | 功能描述:IC DAC NV SELECT OUT/MEM 20TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:2,400 系列:- 设置时间:- 位数:18 数据接口:串行 转换器数目:3 电压电源:模拟和数字 功率耗散（最大）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:36-TFBGA 供应商设备封装:36-TFBGA 包装:带卷 (TR) 输出数目和类型:* 采样率（每秒）:* |
| X79002V20IT1 | 功能描述:IC DAC NV SELECT OUT/MEM 20TSSOP RoHS:否 类别:集成电路 (IC) >> 数据采集 - 数模转换器 系列:- 标准包装:2,400 系列:- 设置时间:- 位数:18 数据接口:串行 转换器数目:3 电压电源:模拟和数字 功率耗散（最大）:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:36-TFBGA 供应商设备封装:36-TFBGA 包装:带卷 (TR) 输出数目和类型:* 采样率（每秒）:* |
| X790A | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:Medium current, high performance, low voltage PNP transistor |
| X7984-125S-M | 制造商:CPI 制造商全称:CPI 功能描述:SOLID STATE HIGH POWER AMPLIFIER MODULES |
发布紧急采购，3分钟左右您将得到回复。