参数资料
| 型号： | S2S4 |
| 厂商： | Sharp Microelectronics |
| 文件页数： | 8/15页 |
| 文件大小： | 0K |
| 描述： | PHOTOCOUPLER 600V TRIAC ZC 4-SMD |
| 产品目录绘图： | Zero Cross Circuit |
| 标准包装： | 50 |
| 电压 - 隔离： | 3750Vrms |
| 通道数： | 1 |
| 电压 - 断路： | 600V |
| 输出类型： | 交流过零三端双向可控硅开关 |
| 电流 - 栅极触发电流 (Igt)（最大）： | 10mA |
| 电流 - 保持 (Ih)： | 100µA |
| 电流 - DC 正向(If)： | 50mA |
| 电流 - 输出 / 通道： | 50mA |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 4-SMD |
| 供应商设备封装： | 4-SMD |
| 包装： | 管件 |
| 其它名称： | 425-1303-5 |
S2S4 Series
■ Design Considerations
● Design guide
In order for the Phototriac to turn off, the triggering current (I F ) must be 0.1mA or less.
Please refrain from using these devices in a direct drive configuration. These Phototriac Coupler are
intended to be used as triggering device for main Triacs. Please ensure that the output rating of these
devices will be sufficient for triggering the main output Triac of your choice. Failure to do may result in
malfunctions.
For applications with inductive loads such as motors, please use caution in utilizing a zero crossing type Pho-
totraiac Coupler as this may cause undesired operations due to the phase difference between voltage and
current of load.
For designs that will experience excessive noise or sudden changes in load voltage, please include an
appropriate snubber circuit as shown in the below circuit. Please keep in mind the Sharp Phototriac Coupler
incorporate superrior dV/dt ratings which can eliminate the need for a snubber circuit.
For over voltage protection, a Varistor may be used.
● Degradation
In general, the emission of the IRED used in Phototriac Couplers will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these Phototriac Couplers should
provide at least twice the minimum required triggering current from initial operation.
● Recommended Foot Print (reference)
6.3
1.5
8
(Unit : mm)
Sheet No.: D2-A06601EN
相关PDF资料 |
PDF描述 |
|---|---|
| 4308R-101-241 | RES ARRAY 240 OHM 7 RES 8-SIP |
| HPKTM1CR-312 | RAIL TERMINAL TAG 1K PER PACK |
| OSTYK50120030 | CONN BARRIER STRIP 20CIRC 9.50MM |
| OSTYK44521030 | CONN BARRIER STRIP 21CIRC 9.50MM |
| OSTYK40321330 | CONN BARRIER STRIP 21CIRC 8.25MM |
相关代理商/技术参数 |
参数描述 |
|---|---|
| S2S4000F | 功能描述:三极与 SCR 输出光电耦合器 10mA Ift 600V 0Cross Phototriac Sleeve RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
| S2S4A | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Zero cross type Mini-Flat Package Phototriac Coupler for triggering |
| S2S4A00F | 功能描述:三极与 SCR 输出光电耦合器 10mA Ift 600V 0Cross Phototriac 3Kpcs RoHS:否 制造商:Vishay Semiconductors 输出设备:PhotoTriac 每芯片的通道数量: 绝缘电压:3750 Vrms 正向电流:10 mA 正向电压:1.2 V 最大触发电流:10 mA 关断状态下输出电压-VDRM:600 V 最大连续输出电流: 零交叉电路: 封装:Reel |
| S2S4AY | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Zero cross type Mini-Flat Package Phototriac Coupler for triggering |
| S2S4AY0F | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Zero cross type Mini-Flat Package Phototriac Coupler for triggering |
发布紧急采购，3分钟左右您将得到回复。