参数资料
| 型号： | A8498SLJ-T |
| 厂商： | Allegro Microsystems Inc |
| 文件页数： | 6/9页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3A 8SOIC |
| 标准包装： | 98 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 24 V |
| 输入电压： | 8 V ~ 50 V |
| PWM 型： | 电流模式 |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -20°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm Width）裸露焊盘 |
| 包装： | 管件 |
| 供应商设备封装： | 8-SOIC-EP |
A8498
Wide Input Voltage 3.0 A Step Down Regulator
The switching frequency is calculated as follows:
to the minimum on-time of the switcher.
f SW =
1
t ON + t OFF
(4)
The extension of the off-time is based on the value of the TSET
multiplier and the FB voltage, as shown in the following table:
V FB (V) TSET Multiplier
Shorted Load. If the voltage on the FB pin falls below 0.4 V, the
regulator will invoke a 1.5 A typical overcurrent limit to handle
the shorted load condition at the regulator output. For low output
voltages at power up and in the case of a shorted output, the off-
time is extended to prevent loss of control of the current limit due
Component Selection
< 0.16
< 0.32
< 0.5
> 0.5
8 × t OFF
4 × t OFF
2 × t OFF
t OFF
L1. The inductor must be rated to handle the total load current.
The value should be chosen to keep the ripple current to a reason-
able value. The ripple current, I RIPPLE , can be calculated by:
Substituting into equation 8:
t ON = 225 mA × 180 μ H / 36.5 V = 1.11 μ s
I RIPPLE = V L(OFF) × t OFF / L
V L(OFF) = V OUT + V f + I L(AV) × R L
(5)
(6)
Substituting into equation 7:
f SW = 1 / (7 μ s +1.11 μ s) = 123 kHz
Higher inductor values can be chosen to lower the ripple cur-
Example:
Given V OUT = 5 V, V f = 0.55 V, V IN = 42 V, I LOAD = 0.5 A, power
inductor with L = 180 μ H and R L = 0.5 Ω Rdc at 55°C, t OFF =
7 μ s, and R DS(on) = 0.5 Ω .
Substituting into equation 6:
V L(OFF) = 5 V + 0.55 V+ 0.5 A × 0.5 Ω = 5.8 V
Substituting into equation 5:
I RIPPLE = 5.8 V × 7 μ s / 180 μ H = 225 mA
The switching frequency, f SW , can then be estimated by:
rent. This may be an option if it is required to increase the total
maximum current available above that drawn from the switching
regulator. The maximum total current available, I LOAD(MAX) , is:
I LOAD(MAX) = I CL (min) – I RIPPLE / 2 (10)
where I CL (min) is 3.5 A, from the Electrical Chracteristics table.
D1. The Schottky catch diode should be rated to handle 1.2 times
the maximum load current. The voltage rating should be higher
than the maximum input voltage expected during all operating
conditions. The duty cycle for high input voltages can be very
close to 100%.
f SW = 1 / ( t ON + t OFF )
t ON = I RIPPLE × L / V L(ON)
V L(ON) = V IN – I L(AV) × R DS(on) – I L(AV) × R L – V OUT
Substituting into equation 9:
(7)
(8)
(9)
COUT. The main consideration in selecting an output capacitor
is voltage ripple on the output. For electrolytic output capacitors,
a low-ESR type is recommended.
The peak-to-peak output voltage ripple is simply I RIPPLE × ESR.
Note that increasing the inductor value can decrease the ripple
V L(ON) = 42 V – 0.5 A × 0.5 Ω – 0.5 A × 0.5 Ω – 5 V = 36.5 V
current. The ESR should be in the range from 50 to 500 m Ω .
Allegro MicroSystems, LLC
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com
6
相关PDF资料 |
PDF描述 |
|---|---|
| A8499SLJ-T | IC REG BUCK ADJ 2A 8SOIC |
| A8582KLPTR-T | IC REG BUCK ADJ 2A 16TSSOP |
| A8583KLPTR-T | IC REG BUCK ADJ 3.5A 16TSSOP |
| A8601KLPTR-T | IC REG MULTIPLE OUTPUT 28-TSSOP |
| A8670EESTR-T | IC REG BUCK ADJ 2A 20QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A8498SLJTR-T | 功能描述:IC REG BUCK ADJ 3A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:250 系列:- 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:1.2V 输入电压:2.05 V ~ 6 V PWM 型:电压模式 频率 - 开关:2MHz 电流 - 输出:500mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UFDFN 包装:带卷 (TR) 供应商设备封装:6-SON（1.45x1） 产品目录页面:1032 (CN2011-ZH PDF) 其它名称:296-25628-2 |
| A8499 | 制造商:ALLEGRO 制造商全称:Allegro MicroSystems 功能描述:High Voltage Step-Down Regulator |
| A8499SLJ-T | 功能描述:IC REG BUCK ADJ 2A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:20 系列:SIMPLE SWITCHER® 类型:降压（降压） 输出类型:固定 输出数:1 输出电压:12V 输入电压:4 V ~ 60 V PWM 型:电压模式 频率 - 开关:52kHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:16-DIP（0.300"，7.62mm） 包装:管件 供应商设备封装:16-DIP 其它名称:*LM2575HVN-12LM2575HVN-12 |
| A8499SLJ-T | 制造商:Allegro MicroSystems 功能描述:Voltage Regulator IC |
| A8499SLJTR-T | 功能描述:IC REG BUCK ADJ 2A 8SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
发布紧急采购，3分钟左右您将得到回复。