- 您现在的位置：买卖IC网 > PDF目录25515 > 951601AFLF (INTEGRATED DEVICE TECHNOLOGY INC) 66.66 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 PDF资料下载
参数资料
| 型号： | 951601AFLF |
| 厂商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分类： | 时钟产生/分配 |
| 英文描述： | 66.66 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 封装： | 0.300 INCH, GREEN, MO-118, SSOP-48 |
| 文件页数： | 6/12页 |
| 文件大小： | 168K |
| 代理商： | 951601AFLF |
3
ICS951601
Preliminary Prouct Preview
0663C—10/04/05
1.
The ICS clock generator is a slave/receiver, I
2C component.It can read back the data stored in the latches
for verification. Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the
controller.The bytes must be accessed in sequential order from lowest to highest byte with the ability to
stop after any complete byte has been transferred. The Command code and Byte count shown above
must be sent, but the data is ignored for those two bytes. The data is loaded until a Stop sequence is
issued.
6.
At power-on, all registers are set to a default condition, as shown.
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D2
(H)
ICS clock will
acknowledge
Controller (host) sends a dummy command code
ICS clock will
acknowledge
Controller (host) sends a dummy byte count
ICS clock will
acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 5
ICS clock will
acknowledge each byte one at a
time.
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D3
(H)
ICS clock will
acknowledge
ICS clock will send the
byte count
Controller (host) acknowledges
ICS clock sends first byte
(Byte 0) through byte
5
Controller (host) will need to acknowledge each
byte
Notes:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D3(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Stop Bit
How to Read:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D2(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Stop Bit
How to Write:
相关PDF资料 |
PDF描述 |
|---|---|
| 951901AF | 133.34 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 951901AFLFT | 133.34 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 951 | WIRE TERMINAL |
| 952001AF | 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 952001AFLF | 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| 951601AFLFT | 功能描述:时钟发生器及支持产品 RoHS:否 制造商:Silicon Labs 类型:Clock Generators 最大输入频率:14.318 MHz 最大输出频率:166 MHz 输出端数量:16 占空比 - 最大:55 % 工作电源电压:3.3 V 工作电源电流:1 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-56 |
| 951603S001 | 制造商:TE Connectivity 功能描述: 制造商:TE Connectivity 功能描述:218M622-19A-CS2209 |
| 9516-060 | 制造商:Belden Inc 功能描述:22-6P PLTC STR TNC PVC OA FOIL SHD PVC JKT CM ITC FT4 |
| 9-516202-1 | 功能描述:CYLINDER HOLDER IN FRONT 制造商:te connectivity amp connectors 系列:* 零件状态:有效 标准包装:1 |
| 9-516202-2 | 功能描述:CYLINDER HOLDER REAR 制造商:te connectivity amp connectors 系列:* 零件状态:有效 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。