3M? Polyimide Film
Electrical Tape 92
Polyimide Film Tape with Silicone Pressure Sensitive Adhesive
Data Sheet
Description
Agency Approvals
& Self Certifications
Applications
Specifications
January 2013
3M? Polyimide Film Electrical Tape 92 is a 1-mil polyimide film backing with
silicone adhesive. Its silicone pressure sensitive adhesive allows it to be used at
356oF (180oC), and it is UL 510 Flame Retardant. Like most insulated tapes,
from 3M, Tape 92 is available in standard and custom widths and lengths. The
standard length is 36 yards, and can be cut to widths ranging from 1/4” to 23”.
Longer lengths up to several times normal length are possible, dependent upon
width. Check with Customer Service.
UL recognized component listing not to exceed 180°C (356°F), Meets flame
retardant requirements of UL510, Product Category OANZ2, and 3M File
No. E17385
UL File Number E17385 A and B, Guide OANZ2. Underwriters Laboratories (UL) recognized products
have been evaluated for use as components of end-product equipment that is listed or classified by
UL. To achieve Underwriters Laboratories recognition, component construction must meet UL
specifications and conditions of acceptability for proper and safe use of the component or product.
Product Category OANZ2, File E17385
RoHS
2011/65/EC
" RoHS 2011/65/EU" means that the product or part does not contain any of the substances in excess
of the maximum concentration values (“MCVs”) in EU RoHS Directive 2011/65/EU. The MCVs are by
weight in homogeneous materials. This information represents 3M's knowledge and belief, which may
be based in whole or in part on information provided by third party suppliers to 3M.
3M Tape 92 is used for high temperature electrical applications in which a tough,
thin insulating material is required for wrapping coils, transformers, capacitors,
wire harnesses, and for anchoring leads / terminal boards. It also is used in
printed circuit board assembly as a wave solder masking tape.
3M? Polyimide Film Electrical Tape 92 is a polyimide film with thermosetting
silicone pressure-sensitive adhesive.
The tape shall be coated on one side with pressure-sensitive adhesive, which
shall not require heat, moisture or other preparation prior to or subsequent to
application. The adhesive coating shall be smooth and uniform and be free of
lumps and bare spots. There shall be no separator between adjacent layers of
the roll. The tape shall perform at a temperature of -40°F (-40°C) to 356°F
(180°C) without substantial loss of tensile or electrical properties
1 of 2
3
